EXD_ Care Guides · Wash and care
Cleaning the engine bay at home, safely
A clean engine bay is nicer to look at and easier to check for leaks, but water in the wrong place is trouble. Cover the alternator, intake and fuse box, use a gentle degreaser and soft brushes, rinse with low pressure, and dry it properly. Never put a pressure-washer jet on the electrics.
Avi Nair, EXD · About 4 minutes · Published 29 September 2026
Opening the bonnet on a clean engine bay is one of the small pleasures of owning a car. It also helps. A fresh oil weep or a split hose is easy to spot on clean plastic and almost invisible under a year of Joburg dust.
But this is the one part of the car where enthusiasm does real damage. Start by reading your handbook. Some makers tell you not to wash the engine compartment with water at all. If yours does, stop at a dry wipe-down.
If you're not sure, leave it. An engine bay is easy to get wrong.
Before you start
- Engine cool. Never clean a hot engine. Wait until everything is cold to the touch.
- Hybrid or electric? Read the next section first.
- Clear the loose stuff. Leaves and twigs by hand, or with a vacuum.
- Cover the sensitive parts. The alternator, the air intake or filter box opening, the fuse and relay box, exposed plugs and connectors, and the battery terminals. Plastic bags and a little tape do the job.
- Check the caps. Oil filler, dipstick and fluid reservoirs firmly closed.
The EXD Engine Bay Method
- A gentle degreaser, diluted as the label says, sprayed on the plastics and painted surfaces. Not on hot parts, not on electrics.
- Soft brushes to agitate. Detailing brushes get round hoses and into corners.
- Rinse gently. A damp microfibre, or a low-pressure shower from a hose, held well back. Never a pressure-washer jet on electrics. A focused jet pushes water past seals made for splashes, not pressure.
- Dry it. A blower or compressed air on the nooks, then a towel. Remove the covers once it's dry.
- Dress the plastics with a water-based dressing so they look clean, not wet and greasy.
- Start and idle for a few minutes with the bonnet open to drive off any leftover moisture.
Hybrids and EVs: be careful
High-voltage cables on hybrids and EVs are usually orange. On some models they are blue. Don't touch them, their connectors or their covers, and never spray water at them. The UK's Health and Safety Executive warns that pressure washing can damage high-voltage components and cables, and that you should follow the maker's guidance before valeting the engine bay. Some components can hold voltage even with the car switched off.
On these cars, wipe the plastic covers well away from the orange or blue cabling and leave the rest. Your handbook has the final word.
Leave it to a pro when
- The handbook says no water in the engine bay.
- It's a hybrid or EV and you're unsure which parts are high voltage.
- There's heavy oil or grease, a leak, or corrosion on terminals.
- It's a show car or a rare engine you'd rather not experiment on.
Our journal post on engine bay cleaning goes into what matters at the studio. If you'd like us to do it, WhatsApp +27 81 063 8786.
Try it
WhatsApp EXD on +27 81 063 8786. 386 Jan Smuts Avenue, Hyde Park, Johannesburg.
.png)