A wet sheet of clear protection film being laid onto a panel at EXD in Hyde Park.

EXD_ Care Guides · Aftercare

XPEL Paint Protection Film: your aftercare

Avi Nair, EXD · About 5 minutes · Published 21 July 2026

Your car carries XPEL paint protection film on the panels we agreed at your inspection. The film is a clear, self-healing urethane layer. It takes the stone chips and light scratches meant for your paint. These notes keep it clear and well bonded for its full life.

If your film also carries XPEL FUSION PLUS, read the FUSION PLUS guide as well.

Don't wash it in the first week. Leave that first wash to us.

Your care timeline

First 24 hours

Do

  • Keep the car dry. No wash and no rinse while the adhesive settles.
  • Where you have the choice, park under cover and out of the rain.

Avoid

  • Pressing, picking or wiping at a corner or edge of the film.

What EXD does

  • Hands the car over at the studio and talks you through these notes.

First week

Do

  • Keep the car unwashed for the first week. No wash and no rinse.
  • Leave the first wash to us.
  • Expect small moisture bubbles or a light haze under fresh film. This is application solution still drying out. Leave them alone.

Avoid

  • Touching the edges. Over the first week the film settles as it contracts and expands with the temperature.

What EXD does

  • Between day 4 and day 7, the car returns to the studio for its final check and seal, with a complimentary wash. Edges are rechecked and trimmed if needed.

First month

Do

  • Hand wash every two weeks, and sooner after gravel roads, rain or bird droppings.
  • Use two buckets, a pH-neutral shampoo with no wax, and a soft microfibre mitt. XPEL Wash Solution and XPEL Foam Soap are made for the film.
  • Wash in the shade on a cool panel. Wheels first, with their own bucket, brush and mitt. Then work from the roof down on the paint.
  • Dry with a plush microfibre towel or an air blower. Never leave water to dry on the film.
  • Lift bugs and bird droppings the same day with a soft microfibre. If the film carries FUSION PLUS, use XPEL Detail Spray or a pH-neutral quick detailer. Skip XPEL Film Cleaner on ceramic-infused film. XPEL South Africa says it is not for that surface. On uncoated film, XPEL Film Cleaner is fine.

Avoid

  • Shared sponges, one-bucket washes and dry wipes. Grit abrades the film.
  • Automatic and brush car washes. A corner hand wash is fine. Ask for a clean mitt, no brushes on the paint, and no harsh degreaser on the film.
  • Wax, polish, cutting compound, clay, solvents, petroleum or paraffin degreasers, and powder or abrasive cleaners on the film.

What EXD does

  • Maintenance Wash at the studio at least every three weeks, if you would like us to.

Six months and ongoing

Do

  • Seal the film with XPEL Ceramic Boost at least once every six months. On STEALTH it keeps the satin finish even.
  • Keep up the two-bucket wash every two weeks.

Avoid

  • Any ceramic coating on the film other than XPEL FUSION PLUS.
  • On STEALTH, any gloss product or wax. Ask us first.
  • A car cover on a wet or dirty car.

What EXD does

  • Six-month condition check, complimentary: a full inspection of the vehicle at the studio. XPEL itself recommends a yearly inspection with your installer, and the six-month check covers it.
  • Maintenance Wash at the studio at least every three weeks. This is our recommendation, to keep road film and minerals from building up.
  • Full decontamination at the studio every three months. Don't clay film at home, and don't use alcohol or solvents on it. If it needs a deeper clean, we do that at the studio as part of a professional decon. Painted panels without film get chemical and clay decontamination.
An EXD installer in XPEL workwear lifting a sheet of clear film into place.
An EXD installer lifting a sheet of clear film into place.

Good to know

  • Light scratches in the film self-heal in 20 to 30 minutes at room temperature. On a cold day, pour warm water (about 49°C) over the mark.
  • Pressure washer: keep the nozzle at least 1 metre from the film, use a wide 40-degree tip, spray square to the panel, and never aim at an edge, seam or wheel-arch lip.
  • Never leave water to dry on the film. Mineral spots stain, and XPEL does not cover water spots.
  • A fine line at the film edge on close inspection is normal. We wrap edges where the panel allows. Where it does not, the edge sits flat and shows only up close.
  • Swirls fading in the sun is the self-healing topcoat at work.
  • We supply XPEL, GYEON or Labocosmetica home-care products, whichever you prefer.

When to contact the studio

  • A bubble still present after a few weeks, or a new bubble.
  • An edge lifting, holding dirt, or turning white.
  • A cut, tear or deep impact mark.
  • Yellowing, cracking, blistering or the film separating from the panel.
  • Before any panel repair or respray. Repaired areas need new film to stay under warranty.
  • Before you use a product you are unsure of.

Send a daylight photo by WhatsApp to +27 81 063 8786, or email bookings@exdetails.co.za.

Warranty

XPEL warrants the film against manufacturing defects, from the date of installation:

FilmXPEL warranty
XPEL XTREME5 years
XPEL EXO ARMOR7 years
XPEL ULTIMATE PLUS10 years
XPEL STEALTH10 years
XPEL ULTIMATE FUSION10 years on the film, plus 4 years on the topcoat against oxidation, loss of gloss, UV damage and fading
  • Covered: yellowing, cracking, blistering and delamination. XPEL repairs or replaces the defective film, parts and labour. A replacement does not restart the period.
  • Not covered: stone and road-debris impact, scratches, stains, water spots, collision, hail and vandalism, incorrect wash methods, harsh chemicals, non-XPEL ceramic coatings, and areas not re-filmed after a repair. The warranty covers the film, not the paint beneath it.
  • Transfer: a new owner keeps the remaining period with proof of the original installation date.
  • Registration: we register your XPEL warranty on your behalf, and you receive your warranty details from the studio. Keep them with your invoice.
  • EXD workmanship: our installation carries a 12-month EXD workmanship promise.
  • Claims: contact us directly. We handle your claim with XPEL from start to finish.

Executive Details, 386 Jan Smuts Avenue, Hyde Park, Johannesburg www.exdetails.co.za | bookings@exdetails.co.za | +27 81 063 8786

Photos: hero IMG_7087.JPG (PPF fitting on a mirror, "PPF Maintain" folder). Edge close-up and day-7 check: shot_list.md.

WhatsApp EXD on +27 81 063 8786. Aftercare questions: bookings@exdetails.co.za. 386 Jan Smuts Avenue, Hyde Park, Johannesburg.